Figure 19-3 Reinitialization Tool - Cisco ONS 15454 Series Procedure Manual

DLP-A244 Use the Reinitialization Tool to Clear the Database and Upload Software (Windows)
Figure 19-3 Reinitialization Tool
Step 5 Complete the following fields:
•
•
•
•
•
•
•
•
•
•
Click Go.
Step 6
Before continuing with the next step, verify that the database to upload is correct. You cannot reverse
Caution
the upload process after you click Yes.
Review the information on the Confirm NE Re-Initialization dialog box, then click Yes to start the
Step 7
reinitialization.
The reinitialization begins. After the software is downloaded and activated and the database is uploaded
to the TCC2/TCC2P cards, "Complete" appears in the status bar and the TCC2/TCC2P cards reboot.
Wait a few minutes for the reboot to complete.
After the reboot is complete, log into the node using the
Step 8
Cisco ONS 15454 Procedure Guide, R5.0
19-26
GNE IP—If the node you are reinitializing is accessed through another node configured as a gateway
network element (GNE), enter the GNE IP address. If you have a direct connection to the node, leave
this field blank.
Node IP—Enter the node name or IP address of the node that you are reinitializing.
User ID—Enter the user ID needed to access the node.
Password—Enter the password for the user ID.
Upload Package—Check this box to send the software package file to the node. If unchecked, the
software stored on the node is not modified.
Force Upload—Check this box to send the software package file to the node even if the node is
running the same software version. If unchecked, reinitialization will not send the software package
if the node is already running the same version.
Activate/Revert—Check this box to activate the uploaded software (if the software is a later than the
installed version) or revert to the uploaded software (if the software is earlier than the installed
version) as soon as the software file is uploaded. If unchecked, the software is not activated or
reverted after the upload, allowing you to initiate the functions later from the node view
Maintenance > Software tabs.
Re-init Database—Check this box to send a new database to the node. (This is equivalent to the CTC
database restore operation.) If unchecked, the node database is not modified.
Confirm—Check this box if you want a warning message displayed before any operation is
performed. If unchecked, reinitialization does not display a warning message.
Search Path—Enter the path to the CISCO15454 folder on the CD drive.
Chapter 19
"DLP-A60 Log into CTC" task on page
DLPs A200 to A299
17-66.
September 2005