Dlp- A259 Refresh Ethernet Pm Counts At A Different Time Interval - Cisco ONS 15454 Series Procedure Manual

DLP-A259 Refresh Ethernet PM Counts at a Different Time Interval
Note
Return to your originating procedure (NTP).
Step 5
DLP-A259 Refresh Ethernet PM Counts at a Different Time Interval
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the Ethernet card where you want to view PM counts. The card view appears.
Step 1
Click the Performance tab.
Step 2
Note
Click the Utilization tab or the History tab.
Step 3
From the Interval drop-down list, choose one of four options:
Step 4
•
•
•
•
Click Refresh. The PM counts refresh with values based on the selected time interval.
Step 5
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15454 Procedure Guide, R5.0
19-42
To refresh, reset, or clear PM counts, see the
on page 8-2.
For CE-Series and ML-Series cards, click the Performance > Ether Ports tabs or the
Performance > POS Ports tabs.
1 min: This option displays the specified PM counts in one-minute time intervals.
15 min: This option displays the specified PM counts in 15-minute time intervals.
1 hour: This option displays the specified PM counts in one-hour time intervals.
1 day: This option displays the specified PM counts in one-day (24 hours) time intervals.
"NTP-A253 Change the PM Display" procedure
This task changes the window view to display specified PM counts in
time intervals depending on the interval option selected.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
Chapter 19 DLPs A200 to A299
September 2005