Dlp- A377 Provision Section Dcc Terminations - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
•
•
Click OK.
Step 5
Return to your origination procedure (NTP).
Step 6
DLP-A377 Provision Section DCC Terminations
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
When SDCC is provisioned, an LDCC termination is allowed on the same port, but is not recommended.
Note
Using SDCC and LDCC on the same port is only needed during a software upgrade if the software
version does not support LDCC. You can provision SDCCs and LDCCs on different ports in the same
node.
In node view, click the Provisioning > Comm Channels > SDCC tabs.
Step 1
Click Create.
Step 2
In the Create SDCC Terminations dialog box, click the ports where you want to create the SDCC
Step 3
termination. To select more than one port, press the Shift key or the Ctrl key.
Note
In the Port Admin State area, click Set to IS to put the port in service.
Step 4
Verify that the Disable OSPF on SDCC Link check box is unchecked.
Step 5
If the SDCC termination is to include a non-ONS node, check the Far End is Foreign check box. This
Step 6
automatically sets the far-end node IP address to 0.0.0.0, which means that any address can be specified
by the far end. To change the default to a specific IP address, see the
Termination" task on page
Click OK.
Step 7
March 2005
Far End is Foreign—Check this box to specify that the LDCC termination is a non-ONS node.
Far end IP—If you checked the Far End is Foreign check box, type the IP address of the far-end node
or leave the 0.0.0.0 default. An IP address of 0.0.0.0 means that any address can be used by the far
end.
This task creates the SONET SDCC terminations required for alarms,
administration data, signal control information, and messages. In this task,
you can also set up the node so that it has direct IP access to a far-end
non-ONS node over the DCC network.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
SDCC is used for ONS 15454 DCC terminations. The SONET LDCCs and the SDCC (when not
used as a DCC termination by the ONS 15454) can be provisioned as DCC tunnels. See the
"DLP-A313 Create a DCC Tunnel" task on page
20-60.
DLP-A377 Provision Section DCC Terminations
20-7.
"DLP-A374 Change a Section DCC
Cisco ONS 15454 Procedure Guide, R5.0
20-61