Dlp- A386 Install Electrical Cables On The Ubic-V Eias - Cisco ONS 15454 Series Procedure Manual

DLP-A386 Install Electrical Cables on the UBIC-V EIAs
DLP-A386 Install Electrical Cables on the UBIC-V EIAs
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco recommends that you plan for future slot utilization and fully cable all SCSI connectors you will
Note
use later.
Starting at the lowest row where you want to install cables on the UBIC-V, place a cable connector over
Step 1
the desired connection point on the UBIC-V EIA.
Figure 20-14
Cisco ONS 15454 Procedure Guide, R5.0
20-70
This task installs DS-1 and DS-3/EC-1 cables on the Universal Backplane
Interface Connector—Vertical (UBIC-V) EIAs.
3/16-inch flat-head screwdriver
DS-1 and DS-3/EC-1 cables, as needed:
DS-1 cable, 150 feet: 15454-CADS1-SD
•
• DS-1 cable, 250 feet: 15454-CADS1-ID
• DS-1 cable, 655 feet: 15454-CADS1-LD
DS-3/EC-1 cable, 75 feet: 15454-CADS3-SD
•
DS-3/EC-1 cable, 225 feet: 15454-CADS3-ID
•
DS-3/EC-1 cable, 450 feet: 15454-CADS3-LD
•
DLP-A190 Install a UBIC-V EIA, page 18-61
As needed
Onsite
None
shows the UBIC-V slot designations.
Chapter 20 DLPs A300 to A399
March 2005