Figure 2-1 Installing The Door Ground Strap Retrofit Kit - Cisco ONS 15454 Series Procedure Manual

Chapter 2 Install Cards and Fiber-Optic Cable
Figure 2-1
Attach the other end of the ground strap to the longer screw on the fiber guide.
Step 3
Attach the lock washer.
a.
Attach the terminal lug.
b.
Using the open-end wrench, attach and tighten the #4 Kepnut (49-0337-01) on the terminal lug.
c.
Note
Replace the left cable-routing channel.
Step 4
Step 5 Using a Phillips screwdriver, insert and tighten the screws for the cable-routing channel.
Figure 2-2
May 2006
Installing the Door Ground Strap Retrofit Kit
To avoid interference with the traffic (line) card, make sure the ground strap is in a flat
position when the door is open. To move the ground strap into a flat position, rotate the
terminal lug counterclockwise before tightening the Kepnut.
shows the shelf assembly with the front door and ground strap installed.
NTP-A20 Replace the Front Door
Cisco ONS 15454 Procedure Guide, R5.0
2-19