Cisco ONS 15454 Series Procedure Manual page 229

Chapter 6 Create Circuits and VT Tunnels
b.
c.
Click Next.
Step 12
Provision the circuit destination:
Step 13
a.
b.
c.
Click Next.
Step 14
Step 15 In the left pane of the Circuit Routing Preferences panel, confirm that the following information is
correct:
•
•
•
•
If the information is not correct, click the Back button and repeat Steps
Step 16
information. If the information is correct, check Route Automatically.
Click Finish.
Step 17
Complete the
Step 18
Stop. You have completed this procedure.
NTP-A142 Create an E-Series Shared Packet Ring Ethernet
Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with
If a high number of VLANs is already used by the network, complete the
Step 2
Available VLANs" task on page 17-99
create a VLAN during each circuit creation task.)
August 2005
From the Slot drop-down list, choose the slot containing the E-Series card that you will use for one
end of the point-to-point circuit.
From the Port drop-down list, choose a port.
From the Node drop-down list, choose the circuit destination node.
From the Slot drop-down list, choose the slot containing the E-Series card that you will use for other
end of the point-to-point circuit.
From the Port drop-down list, choose a port.
Circuit name
Circuit type
Circuit size
ONS nodes
"NTP-A146 Test E-Series Circuits" procedure on page
This procedure creates a shared packet ring Ethernet circuit. It does not
apply to E-Series cards in port-mapped mode.
E-Series Ethernet cards (E100T-12/E100T-G, E1000-2/E1000-2-G) must
be installed at both Ethernet circuit endpoint nodes.
NTP-A127 Verify Network Turn Up, page 6-4
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
NTP-A142 Create an E-Series Shared Packet Ring Ethernet Circuit
at the node where you will create the circuit.
Step 2.
to verify that sufficient VLAN capacity is available. (You will
Cisco ONS 15454 Procedure Guide, R5.0
6 through 15 with the correct
6-72.
"DLP-A99 Determine
6-61