Dlp- A209 Change External Controls Using The Aic-I Card - Cisco ONS 15454 Series Procedure Manual

Chapter 19 DLPs A200 to A299
To provision additional devices, complete Step
Step 5
Click Apply.
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-A209 Change External Controls Using the AIC-I Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note The procedure is the same if you are using the alarm expansion panel (AEP). In this case, the number of
contacts that are shown on the screen is changed accordingly.
Step 1 Verify the external control relays to the ENVIR ALARMS OUT backplane pins. See the
Install Alarm Wires on the Backplane" task on page 17-22
Step 2 In node view, double-click the AIC-I card to display it in card view.
On the External Controls subtab, modify any of the following fields for each external control wired to
Step 3
the ONS 15454 backplane. For definitions of these fields, see the
and Controls on the Alarm Interface Controller-International" procedure on page
•
•
•
•
To provision additional controls, complete
Step 4
Click Apply.
Step 5
Return to your originating procedure (NTP).
Step 6
September 2005
This task changes external control settings on the AIC-I card.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Enabled
Trigger Type
Control Type
Description
DLP-A209 Change External Controls Using the AIC-I Card
4 for each additional device.
for more information.
"NTP-A258 Provision External Alarms
Step 3 for each additional device.
Cisco ONS 15454 Procedure Guide, R5.0
"DLP-A19
7-11.
19-7