Collecting Group History Statistics On An Interface - Cisco ONS 15454 SDH Configuration Manual
Hide thumbs
Also See for ONS 15454 SDH:
- User manual (62 pages) ,
- Manual (40 pages) ,
- Reference manual (22 pages)
Table of Contents
Advertisement
Chapter 21 Configuring RMON
Collecting Group History Statistics on an Interface
You must first configure RMON alarms and events to display collection information.
Beginning in privileged EXEC mode, follow these steps to collect group history statistics on an interface.
This procedure is optional.
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
rmon collection history index
[buckets bucket-number] [interval seconds]
[owner ownername]
Step 4
end
Step 5
show running-config
Step 6
show rmon history
Step 7
copy running-config startup-config
To disable history collection, use the no rmon collection history index interface configuration
command.
This example shows how to collect and show RMON history for the owner root:
ML_Series(config)# interface gigabitethernet1
ML_Series(config-if)# rmon collection history 2 owner root
ML_Series(config-if)# end
ML_Series# show rmon history
Entry 2 is active, and owned by root
Monitors ifIndex.393217 every 1800 second(s)
Requested # of time intervals, ie buckets, is 50,
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Collecting Group History Statistics on an Interface
Purpose
Enter global configuration mode.
Specify the interface on which to collect history, and enter
interface configuration mode.
Group history statistics do not work on
Note
packet-over-SONET/SDH (POS_ interfaces, only on
Ethernet interfaces.
Enable history collection for the specified number of buckets and
time period.
For index, identify the RMON group of statistics. The range
•
is 1 to 65535.
(Optional) For buckets bucket-number, specify the
•
maximum number of buckets desired for the RMON
collection history group of statistics. The range is 1 to
65535. The default is 50 buckets.
•
(Optional) For interval seconds, specify the number of
seconds in each polling cycle. The range is 1 to 3600. The
default is 1800 seconds.
(Optional) For owner ownername, enter the name of the
•
owner of the RMON group of statistics.
Return to privileged EXEC mode.
Verify your entries.
Display the contents of the ML-Series card history table.
(Optional) Save your entries in the configuration file.
21-5
Advertisement
Table of Contents
