Telnetting To The Node Ip Address And Slot Number - Cisco ONS 15454 SDH Configuration Manual

Chapter 3 Initial Configuration
Figure 3-1

Telnetting to the Node IP Address and Slot Number

Users can telnet to the Cisco IOS CLI using the IP address and the slot number of the
ONS 15454 SONET/SDH plus 2000.
Note A Cisco IOS startup configuration file must be loaded and the ML-Series card must be installed and
initialized prior to telnetting to the IP address and slot number plus 2000. See the
File" section on page 3-7
If the ONS 15454 SONET/SDH node is set up as a proxy server, where one ONS 15454 SONET/SDH
Note
node in the ring acts as a gateway network element (GNE) for the other nodes in the ring, telnetting over
the GNE firewall to the IP address and slot number of a non-GNE or end network element (ENE) requires
the user's Telnet client to be SOCKS v5 aware (RFC 1928). Configure the Telnet client to recognize the
GNE as the Socks v5 proxy for the Telnet session and to recognize the ENE as the host.
Obtain the node IP address from the LCD on the front of the physical ONS 15454 SONET/SDH or the
Step 1
IP Addr field shown at the CTC node view
Identify the slot number containing the targeted ML-Series card from either the physical
Step 2
ONS 15454 SONET/SDH or the CTC node view
CTC IOS Window
for more information.
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Telnetting to the Node IP Address and Slot Number
(Figure 3-2).
(Figure 3-2). For example, Slot 13.
"Startup Configuration
3-3