Ce-100T-8 Loopback, J1 Path Trace, And Sonet/Sdh Alarms - Cisco ONS 15454 SDH Configuration Manual

Hide thumbs Also See for ONS 15454 SDH:

Table of Contents

Chapter 24 CE-100T-8 Ethernet Operation

CE-100T-8 Loopback, J1 Path Trace, and SONET/SDH Alarms

The CE-100T-8 card supports terminal and facility loopbacks. It also reports SONET/SDH alarms and

transmits and monitors the J1 Path Trace byte in the same manner as OC-N cards. Support for path

termination functions includes:

H1 and H2 concatenation indication

C2 signal label

Bit interleaved parity 3 (BIP-3) generation

G1 path status indication

C2 path signal label read/write

Path level alarms and conditions, including loss of pointer (LOP), unequipped, payload mismatch,

alarm indication signal (AIS) detection, and remote defect indication (RDI)

J1 path trace for high-order CCAT paths

J2 path trace for high-order VCAT circuits at the member level

J2 path trace for low-order VCAT circuits at the member level

Extended signal label for the low-order paths

Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0

CE-100T-8 Loopback, J1 Path Trace, and SONET/SDH Alarms