Ntp-H72 Modify And Delete Overhead Circuits And Server Trails; Ntp-H73 Create A Monitor Circuit - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin

NTP-H72 Modify and Delete Overhead Circuits and Server Trails

Purpose
Tools/Equipment
Prerequisite Procedures Circuits must exist on the network. See
Required/As Needed
Onsite/Remote
Security Level
Deleting circuits can be service affecting and should be performed during a maintenance window.
Caution
Complete the
Step 1
circuit you want to modify. If you are already logged in, continue with Step 2.
As needed, complete the
Step 2
As needed, complete the
Step 3
As needed, complete the
Step 4
As needed, complete the
Step 5
Stop. You have completed this procedure.

NTP-H73 Create a Monitor Circuit

Purpose
Tools/Equipment
Prerequisite Procedures Bidirectional (two-way) circuits must exist on the network. See
Required/As Needed
Onsite/Remote
Security Level
Monitor circuits cannot be used with EtherSwitch circuits.
Note
For unidirectional circuits, create a drop to the port where the test equipment is attached.
Note
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
6-4
This procedure changes the tunnel type, repairs IP circuits, and deletes
overhead circuits and server trails.
None
Low-order Path Tunnels."
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H118 Change Tunnel Type" task on page
"DLP-H119 Repair an IP Tunnel" task on page
"DLP-H120 Delete Overhead Circuits" task on page
"DLP-H232 Delete a Server Trail" task on page
This procedure creates a monitor circuit that monitors traffic on primary,
bidirectional circuits.
None
"Create Circuits and VC Low-order Path Tunnels."
procedures.
As needed
Onsite or remote
Provisioning or higher
Chapter 6
Chapter 5, "Create Circuits and VC
at a node on the network containing the
17-25.
17-25.
17-26.
18-31.
for circuit creation
Manage Circuits
Chapter 5,
78-19416-01