Figure 4-2 Ons 15310-Ma Sdh Path Protection Fiber Connection Example - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
Figure 4-2
Slot 3
Port 1-1
Tx
Slot 3
Port 1-1
Tx
Complete the
Step 2
protection configuration you are turning up. If you are already logged in, continue with Step 3.
Complete the
Step 3
will serve as the path protection ports on the node. For example, on an ONS 15310-MA SDH, you can
use Node 1/Slot 3/Port 2-1 (STM1) and Node 1/Slot 4/Port 1-1 (STM1). (Alternatively, if additional
bandwidth is needed for CTC management, complete the
task on page
Note
Repeat Steps
Step 4
As needed, complete the
Step 5
As needed, complete the
Step 6
As needed, complete the
Step 7
point-to-point nodes.
Complete the
Step 8
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
4-10
ONS 15310-MA SDH Path Protection Fiber Connection Example
Slot 4
Port 2-1
Rx Tx Rx
Node 1
Slot 4
Port 2-1
Rx Tx Rx
Node 3
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H52 Provision Section DCC Terminations" task on page 16-68
16-71.)
If an ONS 15310-MA SDH is not connected to a corporate LAN, DCC provisioning must be
performed through a craft (direct) connection. Remote provisioning is possible only after all
nodes in the network have DCC terminations provisioned to in-service for ports on the
15310E-CTX-K9 for the ONS 15310-MA SDH.
2 and 3 for each node in the path protection configuration.
"DLP-H47 Provision a Proxy Tunnel" task on page
"DLP-H48 Provision a Firewall Tunnel" task on page
"DLP-H49 Create a Provisionable Patchcord" task on page 16-66
"NTP-H32 Path Protection Acceptance Test" procedure on page
Chapter 4
Slot 4
Slot 3
Port 2-1
Port 1-1
Tx Rx Tx Rx
Node 2
Slot 4
Slot 3
Port 2-1
Port 1-1
Tx Rx Tx Rx
Node 4
at an ONS 15310-MA SDH in the path
"DLP-H53 Provision Line DCC Terminations"
Turn Up a Network
for the two ports that
16-64.
16-65.
on both
4-11.
78-19416-01