Dlp-H78 Search For Circuits - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
An exclusion rule eliminates all lower-level alarms or conditions that originate from the same cause. For
example, a fiber break may cause an LOS alarm, an AIS condition, and an SF condition. If you check
the Exclude Same Root Cause check box, only the LOS alarm will appear. According to Telcordia,
exclusion rules apply to a query of all conditions from a node.
Return to your originating procedure (NTP).
Step 4

DLP-H78 Search for Circuits

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Navigate to the appropriate CTC view:
•
•
•
Step 2 Click the Circuits tab.
Step 3 If you are in node or card view, choose the scope for the search, Node or Network (All), in the Scope
drop-down list located at the bottom right-hand side of the screen.
Click Search.
Step 4
Step 5 In the Circuit Name Search dialog box, complete the following:
•
•
•
•
Click Find Next. If a match is found, click Find Next again to find the next circuit.
Step 6
Repeat Steps
Step 7
Return to your originating procedure (NTP).
Step 8
78-19416-01
This task searches for ONS 15310-MA SDH circuits at the network, node,
or card level.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
To search the entire network, click View > Go to Network View.
To search for circuits that originate, terminate, or pass through a specific node, click View > Go to
Other Node, then choose the node you want to search and click OK.
To search for circuits that originate, terminate, or pass through a specific card, double-click the card
on the shelf graphic in node view to open the card in card view.
Find What—Enter the text of the circuit name you want to find.
Match whole word only—Check this check box to instruct CTC to select circuits only if the entire
word matches the text in the Find What field.
Match case—Check this check box to instruct CTC to select circuits only when the capitalization
matches the capitalization entered in the Find What field.
Direction—Choose the direction for the search. Searches are conducted up or down from the
currently selected circuit.
5 and 6 until you are finished, then click Cancel.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-95