Ntp-H177 Set Up The Ons 15310-Ma Sdh In Ems Secure Access; Ntp-H22 Set Up The Ons 15310-Ma Sdh For Firewall Access - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 3 Turn Up a Node

NTP-H177 Set Up the ONS 15310-MA SDH in EMS Secure Access

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Security > Access pane.
Step 1
Under the EMS Access area, change the Access State to Secure.
Step 2
Click Apply. The CTC disconnects and reconnects through a secure socket connection.
Step 3
To create a secure connection, enter https://node-address.
Step 4
Note After setting up a CTC connection in secure mode, http requests are automatically redirected to https
mode.
A first time connection is authenticated by the Website Certification is Not Known dialog box. Accept
Step 5
the certificate and click OK. The Security Error: Domain Name Mismatch dialog box appears. Click
OK to continue.
Stop. You have completed this procedure.

NTP-H22 Set Up the ONS 15310-MA SDH for Firewall Access

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with Step 2.
78-19416-01
This procedure provisions ONS 15310-MA SDH and CTC computers for
secure access.
None
NTP-H21 Set Up CTC Network Access, page 3-6
As needed
Onsite or remote
Superuser
This procedure provisions ONS 15310-MA SDH nodes and CTC
computers for access through firewalls. If an ONS 15310 or CTC computer
resides behind a firewall that uses port filtering, you must enable an
Internet Inter-ORB Protocol (IIOP) port on the ONS 15310 SDH and/or
CTC computer, depending on whether one or both devices reside behind a
firewall.
IIOP listener port number provided by your LAN or firewall administrator
NTP-H148 Verify Card and SFP Installation, page 3-2
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
at a node that is behind the firewall. If you
3-7