Dlp-H47 Provision A Proxy Tunnel - Cisco ONS 15310-MA SDH Procedure Manual

•
•
•
In the Reference Lists area, enter the following information:
Step 3
•
•
Click Apply.
Step 4
In node view, click the Provisioning > Timing > BITS Facilities tabs.
Step 5
Step 6 In the BITS In State drop-down list, change State to OOS. Disregard the other BITS Facilities settings;
they are not relevant to internal timing.
Click Apply.
Step 7
Return to your originating procedure (NTP).
Step 8

DLP-H47 Provision a Proxy Tunnel

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If the SOCKS proxy server is disabled, you cannot set up a proxy tunnel.
Note
Click the Provisioning > Network > Proxy subtabs.
Step 1
Click Create.
Step 2
In the Create Tunnel dialog box, complete the following:
Step 3
•
•
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-64
Quality of RES—Not relevant to internal timing; ignore this field.
Revertive—Not relevant to internal timing; ignore this field.
Reversion Time—Not relevant to internal timing; ignore this field.
NE Reference
Ref 1—Set to Internal Clock.
–
Ref 2—Set to Internal Clock.
–
Ref 3—Set to Internal Clock.
–
BITS 1 Out—Set to None.
This task sets up a proxy tunnel to communicate with a non-ONS far-end
node. Proxy tunnels are only necessary when the SOCKS proxy server is
enabled and a foreign DCC termination exists, or if static routes exist so
that the DCC network is used to access remote networks or devices. You
can provision a maximum of 12 proxy server tunnels.
None
DLP-H29 Log into CTC, page 16-43
DLP-H52 Provision Section DCC Terminations, page 16-68
As needed
Onsite or remote
Superuser only
Source Address—Type the IP address of the source node (32 bit length) or source subnet (any other
length).
Source Length—Choose the length of the source subnet mask.
Chapter 16 DLPs H1 to H99
78-19416-01