Dlp-H283 Create Mib Views; Dlp-H284 Create Group Access - Cisco ONS 15310-MA SDH Procedure Manual

Click OK to save the information.
Step 4
Return to your originating procedure (NTP).
Step 5

DLP-H283 Create MIB Views

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > SNMP > SNMP V3 > MIB views tabs.
Step 1
Click Create.
Step 2
In the Create Views dialog box, enter the following information:
Step 3
•
•
•
•
Click OK to save the information.
Step 4
Return to your originating procedure (NTP).
Step 5

DLP-H284 Create Group Access

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, click the Provisioning > SNMP > SNMP V3 > Group Access tabs.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-82
Password—Enter a password if you select DES.
–
This procedure creates an SNMPv3 MIB view.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
Name—Name of the view.
Subtree OID—The MIB subtree which, when combined with the mask, defines the family of
subtrees.
Bit Mask—A family of view subtrees. Each bit in the bit mask corresponds to a sub-identifier of the
subtree OID.
Type—Select the view type. Options are Include and Exclude. Type defines whether the family of
subtrees that are defined by the subtree OID and the bit mask combination are included or excluded
from the notification filter.
This procedure creates a user group and configures the access parameters
for the users in the group.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
Chapter 18 DLPs H200 to H299
78-19416-01