Dlp-H164 Manually Route A Path Protection Circuit In A Topology Upgrade; Dlp-H165 Automatically Route A Path Protection Circuit In A Topology Upgrade - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 17 DLPs H100 to H199

DLP-H164 Manually Route a Path Protection Circuit in a Topology Upgrade

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In the Circuit Routing Preferences area of the Uprotected to Path Protection page, uncheck Route
Automatically.
Click Next. In the Route Review and Edit area, node icons appear for you to route the circuit. The circuit
Step 2
source node is selected. Green arrows pointing from the source node to other network nodes indicate
spans that are available for routing the circuit.
Click Finish.
Step 3
Return to your originating procedure (NTP).
Step 4

DLP-H165 Automatically Route a Path Protection Circuit in a Topology Upgrade

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the Circuit Routing Preferences area of the Unprotected to Path Protection page, check Route
Step 1
Automatically.
Check Review Route Before Creation if you want to review and edit the circuit route before the circuit
is created.
Choose one of the following:
Step 2
•
78-19416-01
This task creates a manually routed USPR circuit during a conversion
from an unprotected point-to-point or linear ADM system to a path
protection configuration.
None
DLP-H29 Log into CTC, page 16-43
NTP-H96 Convert an Unprotected Point-to-Point or Linear ADM to a
Path Protection Configuration Automatically, page 12-5
As needed
Onsite or remote
Provisioning or higher
This task creates an automatically routed USPR circuit during a
conversion from an unprotected point-to-point or linear ADM system to
a path protection configuration.
None
DLP-H29 Log into CTC, page 16-43
NTP-H96 Convert an Unprotected Point-to-Point or Linear ADM to a
Path Protection Configuration Automatically, page 12-5
As needed
Onsite or remote
Provisioning or higher
Nodal Diversity Required—Ensures that the primary and alternate paths within path protection
portions of the complete circuit path are nodally diverse.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-57