Ntp-H55 Create Overhead Circuits - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
•
To set preferences for all members, complete the following in the Set Preferences for All Members area:
Step 13
•
•
Click Next. If you chose Fully Protected, click OK to continue. If not, continue with the next step.
Step 14
In the Route Review and Edit area, node icons appear so you can route the circuit manually.
Step 15
Complete the
Step 16
Click Finish. If the path does not meet the specified path diversity requirement, CTC displays an error
Step 17
message and allows you to change the circuit path.
Note
When all the circuits are created, the main Circuits window appears. Verify that the circuits you created
Step 18
appear in the window.
As needed, complete the
Step 19
page 17-85
page
Stop. You have completed this procedure.

NTP-H55 Create Overhead Circuits

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The ONS 15310-MA SDH support pass-through orderwire circuits if the source and destination are on
Note
ONS 15454 node optical ports. For more information, refer to the Cisco ONS 15454 Procedure Guide.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
5-50
DRI—(Split routing only) Routes the member on a DRI circuit.
–
Node-Diverse Path—(Split routing only) Available for each member when Fully Protected is
chosen.
Protection—Choose the member protection type:
Fully Protected—Routes the circuit on a protected path.
–
Unprotected—Creates an unprotected circuit.
–
PCA—(Future use) Routes the member on a MS-SPRing protection channel.
–
DRI—(Split routing only) Routes the member on a DRI circuit.
–
Node-Diverse Path—(Split routing only) Available when Fully Protected is chosen.
"DLP-H66 Provision a VCAT Circuit Route" task on page
Depending on the complexity of the network and number of members, the VCAT circuit creation
process might take several minutes.
"DLP-H190 Provision CE-100T-8 and CE-MR-6 Card Ethernet Ports" task on
and/or the "DLP-H191 Provision CE-100T-8 and CE-MR-6 Card POS Ports" task on
17-87.
This procedure creates overhead circuits on an ONS network. Overhead
circuits include DCC tunnels, orderwire, UDC circuits, and IP tunnels.
None
NTP-H36 Verify Network Turn-Up, page 5-4
As needed
Onsite or remote
Provisioning or higher
Chapter 5 Create Circuits and VC Low-order Path Tunnels
16-83.
78-19416-01