Ntp- H154 Install The Ethernet Cards - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 1 Install the Cisco ONS 15310-MA SDH
NTP-H154 Install the Ethernet Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Ethernet cards can be installed in any traffic card slot (Slot 1, 2, 5, or 6).
Note
Do not install CE-100T-8 and ML-100T-8 cards in OSP.
Caution
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Warning Connect the copper Ethernet ports to intrabuilding or nonexposed wiring and cabling only.
Statement 1084
Warning The Ethernet ports and the LAN port on 15310E-CTX-K9 cards of ONS 15310-MA SDH are intra-building
ports and are suitable only for connecting to cat-5 shielded (STP) cabling grounded at both
ends.Statement 1084
Warning The CRAFT ports of ONS 15310-MA SDH are intra-building ports to be used for setup and maintenance
purposes by trained personnel and are not connected during normal operation.Statement 1085
Do not install an Ethernet card in an ONS 15310-MA SDH if the ambient temperature exceeds 149
Caution
degrees F (65 degrees C).
Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. For
Caution
detailed instructions on how to wear the ESD wristband, refer to the
(ESD) and Grounding
78-19416-01
This procedure installs the Ethernet cards (CE-100T-8, CE-MR-6, or
ML-100T-8) in the ONS 15310-MA SDH.
None
DLP-H8 Turn On and Verify DC Office Power on the ONS 15310-MA
SDH, page 16-9
As needed
Onsite
Retrieve or higher
Guide.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Required Tools and Equipment
Cisco ONS Electrostatic Discharge
1-19