Ntp-H136 Convert A Point-To-Point To A Linear Adm Automatically - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
NTP-H136 Convert a Point-to-Point to a Linear ADM
Automatically
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Optical transmit and receive levels should be in their acceptable range as shown in the specifications
Note
section for each card in
If overhead circuits exist on the network, an in-service topology upgrade is service affecting. The
Note
overhead circuits will drop traffic and have a status of PARTIAL after the upgrade is complete.
Complete the
Step 1
ADM. If you are already logged in, continue with
In network view, right-click the span between the two nodes where you want to add the new node. The Select
Step 2
Upgrade Protection dialog box appears.
Select Terminal to Linear in the drop-down list. The first page of the wizard, Upgrade Protection:
Step 3
Terminal to Linear, appears.
The Upgrade Protection: Terminal to Linear page lists the following conditions that must be met before
Step 4
adding a new node:
•
•
•
•
•
If all of these conditions are met and you wish to continue with the procedure, click Next.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
12-2
This procedure converts a point-to-point configuration (two nodes) to a
linear ADM (three or more nodes) by adding a third node between two
nodes in a 1+1 configuration. The node being added must be an
ONS 15454, ONS 15454 SDH, ONS 15327, ONS 15310-MA SDH, or
ONS 15600. If you have an ONS 15310-MA SDH with only two optical
ports in use, you can also follow this procedure.
None
The in-service topology upgrade procedure requires that the node being
added is reachable (has IP connectivity with CTC).
If the PC running CTC and the ONS 15310-MA SDH nodes are not at
the same location, two technicians who can communicate with each
other during the upgrade might be needed.
As needed
Onsite
Provisioning or higher
Table 1-2 on page 1-30
"DLP-H29 Log into CTC" task on page 16-43
The terminal network has no critical or major alarms.
The node that you will add has no critical or major alarms.
The node has a compatible software version with that of the terminal nodes.
The node has four unused optical ports matching the speed of the 1+1 protection and no
communications channel has been provisioned on these four ports.
Fiber is available to connect the added node to the terminal nodes.
Chapter 12
for the ONS 15310-MA SDH.
at a node on the point-to-point or linear
Step 2.
Convert Network Configurations
78-19416-01