Ntp- H167 Install The Eias - Cisco ONS 15310-MA SDH Procedure Manual

Required Tools and Equipment
If you plan to install electrical interface assemblies (EIAs), continue with the
Step 3
EIAs" procedure on page
procedure on page
Stop. You have completed this procedure.
NTP-H167 Install the EIAs
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Connect only SELV services to the high-density EIAs on the ONS 15310-MA SDH.
Caution
Determine which high-density EIA is designed for installation on the B Side and which is designed for
Step 1
installation on the A Side
For both OSP and non-OSP installations on the ONS 15310-MA SDH, following ONS 15310-MA SDH
EIAs must be installed:
•
•
Note
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
1-10
1-10. If not, continue with the
1-12.
This procedure describes how to install electrical interface assemblies
(EIAs).
#2 Phillips screwdriver
High-density EIAs
6-32 x 5/16-inch pan head screws (3, included with EIA)
NTP-H169 Install the Cable Management Bracket, page 1-6
As needed
Onsite
None
(Figure
15310E-EIA-HDA=, PN 800-29917-01
15310E-EIA-HDB=, PN 800-29918-01
For information about OSP installation, refer to the installation manual provided with the OSP
cabinet.
"NTP-H151 Install the Power and Ground"
1-4).
Chapter 1 Install the Cisco ONS 15310-MA SDH
"NTP-H167 Install the
78-19416-01