Ntp-H160 Install Optical Cables - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 1 Install the Cisco ONS 15310-MA SDH

NTP-H160 Install Optical Cables

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Class 1 laser product. Statement 1008
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH.For
Caution
detailed instructions on how to wear the ESD wristband, refer to the
(ESD) and Grounding
You can install the fiber immediately after installing the SFPs, or wait until you are ready to turn up the
Note
network. See
Inspect and clean all fiber connectors thoroughly. See the
Note
procedure on page 14-11
connectors that are not used.
To install fiber-optic cables in the ONS 15310-MA SDH, a fiber cable with the corresponding connector
Note
type must be connected to the transmit and receive ports on the SFPs. On ONS 15310-MA SDH ports,
the transmit and receive fiber for each optical signal are contained within a single SFP port.
Measure the optical receive levels using an optical power meter, compare the results with the allowable
Step 1
optical power levels for the installed SFPs, and attenuate accordingly. See
and maximum levels for each SFP type.
78-19416-01
This procedure describes how to install fiber-optic cables in SFPs on the
ONS 15310-MA SDH.
Single-mode fiber jumpers with LC connectors
Fiber boot
Optical power meter
Optical attenuators, as necessary
DLP-H16 Install SFP Connectors, page 16-19
As needed
Onsite
None
Guide.
Chapter 4, "Turn Up a Network."
for instructions. Dust particles can degrade performance. Put caps on any fiber
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Required Tools and Equipment
Cisco ONS Electrostatic Discharge
"NTP-H109 Clean Fiber Connectors"
Table 1-2 for the minimum
1-29