Ntp-H31 Provision Path Protection Nodes - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 4 Turn Up a Network
Remove any loopbacks, switches, or test sets from the nodes after all testing is complete. Refer to the
Step 15
Cisco ONS 15310-MA SDH Troubleshooting Guide if necessary.
Step 16 In network view, click the Alarms tab and click Synchronize. Verify that the network does not have any
unexplained alarms. If unexplained alarms are present, resolve them before continuing. Refer to the
Cisco ONS 15310-MA SDH Troubleshooting Guide if necessary.
Delete the test circuit. See the
Step 17
Repeat Steps
Step 18
If a node fails any test, repeat the test while verifying correct setup and configuration. If the test fails
Step 19
again, refer to the next level of support.
After all tests are successfully completed and no alarms exist in the network, the network is ready for
service application.
Stop. You have completed this procedure.

NTP-H31 Provision Path Protection Nodes

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Path protection is the default ONS 15310-MA SDH topology. It is available as soon as you install the
Note
SFPs (which provide the optical ports), connect the STM-M fibers, and create the DCC terminations.
For the ONS 15310-MA SDH, verify that the fiber is correctly connected to the path protection trunk
Step 1
(span) optical ports similar to
page
78-19416-01
"DLP-H115 Delete Circuits" task on page 17-19
5 through 17 for the next linear ADM node you are testing.
This procedure provisions nodes for inclusion in a path protection
configuration. A path protection configuration is created after the fiber
connections are made.
None
NTP-H26 Verify Node Turn-Up, page 4-2
As needed
Onsite
Superuser
Figure
1-29.
4-2. See the "NTP-H160 Install Optical Cables" procedure on
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
for instructions.
4-9