Dlp-H236 Change Line And Threshold Settings For Ds-3 Ports - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Although Cisco does not recommend changing the LSP (Link State Protocol Data Unit) buffer sizes, you
Step 3
can change the L1 LSP Buffer Size field to change the Level 1 link state PDU buffer size.
Step 4 Return to your originating procedure (NTP).

DLP-H236 Change Line and Threshold Settings for DS-3 Ports

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Refer to the "Network Element Defaults" appendix in the Cisco ONS 15310-MA SDH Reference Manual
Note
for DS-3 port default settings.
In node view, double-click the E1_21_E3_DS3_3, or E1_63_E3_DS3_3 card where you want to change
Step 1
line or threshold settings.
Click the Provisioning > DS-3 tabs.
Step 2
Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
Step 3
or SDH Thresholds subtab.
Note
Modify the settings found under these tabs by clicking in the field that you want to modify. In some
Step 4
fields, you can choose an option from a drop-down list; in others you can type a value.
Click Apply.
Step 5
Repeat Steps
Step 6
For definitions of the line settings, see
Table 18-8 on page
page
Table 18-7
78-19416-01
This task changes the line and threshold settings for DS-3 ports on the
E1_21_E3_DS3_3 and E1_63_E3_DS3_3 cards.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
If you want to modify a threshold setting, it might be necessary to click the available directional,
type, and interval (15 Min, 1 Day) radio buttons and then click Refresh. This will display the
desired threshold setting.
4 and 5 for each subtab that has parameters you want to provision.
18-41. For definitions of the electrical path threshold settings, see
18-42. For definitions of the SDH threshold settings, see
describes the values on the Provisioning > Line tab for the DS-3 ports.
Table 18-7. For definitions of the line threshold settings, see
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Table 18-9 on
Table 18-10 on page 18-42.
18-39