Dlp-H118 Change Tunnel Type; Dlp-H119 Repair An Ip Tunnel - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 17 DLPs H100 to H199

DLP-H118 Change Tunnel Type

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > Overhead Circuits tabs.
Step 2
Click the circuit tunnel that you want to convert.
Step 3
Click Edit.
Step 4
In the Edit circuit window, click the Tunnel tab.
Step 5
In the Attributes area, complete the following:
Step 6
•
•
Click Apply.
Step 7
In the confirmation dialog box, click Yes to continue.
Step 8
In the Circuit Changed status box, click OK to acknowledge that the circuit change was successful.
Step 9
Return to your originating procedure (NTP).
Step 10

DLP-H119 Repair an IP Tunnel

Purpose
Tools/Equipment
Prerequisite Procedures See
Required/As Needed
Onsite/Remote
Security Level
78-19416-01
This task converts a traditional DCC tunnel to an IP-encapsulated tunnel or
an IP-encapsulated tunnel to a traditional DCC tunnel.
None
DLP-H67 Create a DCC Tunnel, page 16-84
DLP-H69 Create an IP-Encapsulated Tunnel, page 16-86
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
If you are converting a traditional DCC tunnel to an IP-encapsulated tunnel, check the Change to
IP Tunnel check box and type the percentage of total RS-DCC bandwidth used in the IP tunnel (the
minimum percentage is 10%).
If you are converting an IP tunnel to a traditional DCC tunnel, check the Change to RS-DCC
Tunnel check box.
This task repairs circuits that have a OOS-PARTIAL status as a result of
node IP address changes.
None
circuit creation procedures.
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Chapter 5, "Create Circuits and VC Low-order Path Tunnels"
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
or
for
17-25