Dlp-H11 Install The Serial Cable For An Ons 15310-Ma Sdh Tl1 Craft Interface; Figure 16-9 Bits Out Pins On The Rj-45 Connector; Table 16-2 Tl1 Serial Cable Pin Assignments - Cisco ONS 15310-MA SDH Procedure Manual

Figure 16-9
Note
Return to your originating procedure (NTP).
Step 3

DLP-H11 Install the Serial Cable for an ONS 15310-MA SDH TL1 Craft Interface

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Plug one end of the TL1 cable into the CRAFT port on the front of the ONS 15310-MA SDH.
Step 2 Connect the other end to the PC you want to use to access the craft.
Table 16-2
Table 16-2
RJ-45 Pin
Number
1
2
3
4
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-12
BITS Out Pins on the RJ-45 Connector
BITS Out
Pin 2 (–)
Pin 1 (+)
For more detailed information about timing, refer to the "Timing" chapter of the
Cisco ONS 15310-MA SDH Reference Manual. To set up system timing, see the
Up Timing" procedure on page
This task installs the TL1 craft interface cable on an ONS 15310-MA SDH.
CAT-5 RJ-45 cable
NTP-H150 Install the Shelf Assembly, page 1-5
As needed
Onsite
None
shows the serial cable pin assignments.
TL1 Serial Cable Pin Assignments
Function
RTS
DTR
TXD
GND
3-10.
Chapter 16 DLPs H1 to H99
"NTP-H23 Set
78-19416-01