Dlp-H116 Add A Member To A Vcat Circuit - Cisco ONS 15310-MA SDH Procedure Manual

•
•
Step 9 If you want to save the information in the CTC Alerts dialog box, complete the following steps. If you
do not want to save, continue with the next step.
a.
b.
c.
Step 10 Click Close to close the CTC Alerts dialog box.
Step 11 Complete the
Return to your originating procedure (NTP).
Step 12

DLP-H116 Add a Member to a VCAT Circuit

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Adding a member to non-LCAS VCAT circuits can be service affecting.
Adding a member to LCAS VCAT circuits in the unlocked-enabled;
Caution
unlocked-disabled,automaticInService; or locked-enabled,maintenance service state could be service
affecting. Cisco recommends using the locked-enabled,outOfGroup service state when adding new
members. You can put the member in the desired state after adding the member.
Note You cannot add members to VCAT circuits that use a Cisco ONS 15454 ML-Series card as a source or
destination.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-20
If you checked "Notify when completed," the CTC Alerts dialog box appears. If you want to save
the information, continue with
Step 10.
If you did not check "Notify when completed," the Circuits window appears. Continue with
Click Save.
Click Browse and navigate to the directory where you want to save the file.
Type the file name using a .txt file extension, and click OK.
"NTP-H102 Back Up the Database" procedure on page
This task adds a member to non-LCAS and LCAS circuits on CE-100T-8,
CE-MR-6, or ML-100T-8 cards.
Adding a member to a VCAT circuit changes the size of the circuit. The
new members use the VCAT member source, destination, and routing
preference (common fiber or split fiber) specified during the VCAT circuit
creation procedure.
CE-100T-8, CE-MR-6, or ML-100T-8 card
DLP-H29 Log into CTC, page 16-43
VCAT circuits must exist on the network. See
and VC Low-order Path Tunnels"
As needed
Onsite or remote
Provisioning or higher
Step 9. If you do not want to save the information, continue with
Chapter 17 DLPs H100 to H199
14-2.
Chapter 5, "Create Circuits
for circuit creation procedures.
Step 11.
78-19416-01