Ntp-H30 Linear Adm Network Acceptance Test - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 4 Turn Up a Network
Note
Note
As needed, complete the
Step 6
As needed, complete the
Step 7
As needed, complete the
Step 8
ADM nodes.
Verify that timing has been set up at each linear node. If not, complete the
Step 9
procedure on page
Complete the
Step 10
Stop. You have completed this procedure.

NTP-H30 Linear ADM Network Acceptance Test

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
ADM network you are testing. If you are already logged in, continue with Step 2.
From the View menu choose Go to Network View.
Step 2
Click the Alarms tab and click Synchronize.
Step 3
a.
b.
c.
78-19416-01
If linear ADM nodes are not connected to a LAN, you will need to create the DCC terminations
using a craft (direct) connection to the node. Remote provisioning is possible only after all nodes
without LAN connections have DCC terminations provisioned to in-service optical ports.
Terminating nodes will have one DCC termination (Nodes 1 and 3 in
and intermediate nodes will have two DCC terminations (Node 2/Slot 5 and Node 2/Slot 12 in
Figure 4-1). An ONS 15310-MA SDH can be used as an intermediate node.
"DLP-H47 Provision a Proxy Tunnel" task on page
"DLP-H48 Provision a Firewall Tunnel" task on page
"DLP-H49 Create a Provisionable Patchcord" task on page 16-66
3-10.
"NTP-H30 Linear ADM Network Acceptance Test" procedure on page
This procedure tests a linear ADM network.
Test set/cables appropriate to the test circuit you will create
NTP-H29 Provision a Linear ADM Network, page 4-6
As needed
Onsite
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
Verify that the alarm filter is not on. See the
page 16-107 as necessary.
Verify that no unexplained alarms appear on the network. If alarms are present, investigate and
resolve them before continuing. Refer to the Cisco ONS 15310-MA SDH Troubleshooting Guide if
necessary.
Complete the "DLP-H223 Export CTC Data" task on page 18-20
your hard drive.
"DLP-H88 Disable Alarm Filtering" task on
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
Figure 4-1 on page
16-64.
16-65.
"NTP-H23 Set Up Timing"
4-7.
at an ONS 15310-MA SDH on the linear
to export alarm data to a file on
4-6),
on all linear
4-7