Dlp-H64 Provision An Stm-M Circuit Route; Dlp-H65 Provision A Vcat Circuit Source And Destination - Cisco ONS 15310-MA SDH Procedure Manual

DLP-H64 Provision an STM-M Circuit Route

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the Circuit Creation wizard in the Route Review and Edit area, click the source node icon if it is not
Step 1
already selected.
Starting with a span on the source node, click the arrow of the span you want the circuit to travel. The
Step 2
arrow turns white. In the Selected Span area, the From and To fields display span information. The
source VC high-order path and if applicable, VC low-order path appears.
Step 3 If you want to change the source VC high-order path, choose a different VC high-order path from the
Source VC high-order path drop-down list; otherwise, continue with
Step 4 If you want to change the source VC low-order path, choose a different VC low-order path from the
Source VC low-order path drop-down list; otherwise, continue with
Step 5 Click Add Span. The span is added to the Included Spans list and the span arrow turns blue.
Step 6 Repeat Steps
all intermediary nodes. If Fully Protect Path is checked on the Circuit Routing Preferences page, you
must complete the following:
•
•
Return to your originating procedure (NTP).
Step 7

DLP-H65 Provision a VCAT Circuit Source and Destination

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Node drop-down list, choose the node where the circuit will originate.
Step 1
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-82
This task provisions the circuit route for manually routed STM-M circuits.
None
DLP-H29 Log into CTC, page 16-43
The Circuit Creation wizard Route Review and Edit page must be open.
As needed
Onsite or remote
Provisioning or higher
2 through 5 until the circuit is provisioned from the source to the destination node through
Add two spans for all path protection or unprotected portions of the circuit route from the source to
the destination.
Add one span for all 1+1 portions of the route from the source to the destination.
This task provisions a VCAT circuit source and destination.
None
DLP-H29 Log into CTC, page 16-43
The Circuit Creation wizard Circuit Source page must be open.
As needed
Onsite or remote
Provisioning or higher
Chapter 16 DLPs H1 to H99
Step 4.
Step 5.
78-19416-01