Ntp-H23 Set Up Timing; Ntp-H142 Create Protection Groups For Ons 15310-Ma Sdh - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin

NTP-H23 Set Up Timing

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
you want to set up timing. If you are already logged in, continue with Step 2.
Complete the
Step 2
integrated timing supply (BITS) source is available. This is the most common SDH timing setup
procedure.
Complete the
Step 3
external BITS source is not available). This task can only provide Stratum 3 timing.
Note
Stop. You have completed this procedure.

NTP-H142 Create Protection Groups for ONS 15310-MA SDH

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
protection group. If you are already logged in, continue with Step 2.
Table 3-1
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
3-10
This procedure provisions the ONS 15310-MA SDH timing.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
Required
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H45 Set Up External or Line Timing" task on page 16-61
"DLP-H46 Set Up Internal Timing" task on page 16-63
For information about SDH timing, refer to the Cisco ONS 15310-MA SDH Reference Manual
or to Telcordia GR-253-CORE.
This procedure creates ONS 15310-MA SDH card protection groups.
None
NTP-H130 Manage Pluggable Port Modules, page 9-3
NTP-H148 Verify Card and SFP Installation, page 3-2
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
describes the protection types available on the ONS 15310-MA SDH.
Chapter 3
at the ONS 15310-MA SDH node where
if an external building
if you cannot complete
(optional)
at the node where you want to create the
Turn Up a Node
Step 2 (an
78-19416-01