Dlp-H204 Add A Tarp Manual Adjacency Table Entry - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 1
Click the static entry that you want to delete.
Step 2
Click Delete Static Entry.
Step 3
In the Delete TDC Entry dialog box, click Yes.
Step 4
Return to your originating procedure (NTP).
Step 5

DLP-H204 Add a TARP Manual Adjacency Table Entry

Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
In the node view, click the Provisioning > OSI > TARP > MAT tabs.
Step 1
Click Add.
Step 2
In the Add TARP Manual Adjacency Table Entry dialog box, enter the following:
Step 3
•
•
Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the Add Static
Step 4
Entry dialog box.
Return to your originating procedure (NTP).
Step 5
78-19416-01
This task adds an entry to the TARP manual adjacency table (MAT). Entries
are added to the MAT when the ONS 15310-MA SDH must communicate
across routers or non-SDH NEs that lack TARP capability.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Level—Sets the TARP Type Code that will be sent:
– Level 1—Indicates that the adjacency is within the same area as the current node. The entry
generates Type 1 PDUs.
Level 2—Indicates that the adjacency is in a different area than the current node. The entry
–
generates Type 2 PDUs.
NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-5