Dlp-H113 Change Active And Standby Span Color - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 17 DLPs H100 to H199
In the Circuits window, verify that the circuit was correctly renamed.
Step 8
Return to your originating procedure (NTP).
Step 9

DLP-H113 Change Active and Standby Span Color

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Edit menu in node view, choose Preferences.
Step 1
In the Preferences dialog box, click the Circuit tab.
Step 2
Complete one or more of the following steps, as required:
Step 3
•
•
•
As needed, change the color of the active span:
Step 4
a.
b.
c.
As needed, change the color of the standby span:
Step 5
a.
b.
c.
Return the active and standby spans to their default colors:
Step 6
a.
b.
c.
d.
78-19416-01
This task changes the color of active (working) and standby (protect)
circuit spans on the detailed circuit map of the Edit Circuits window. By
default, working spans are green and protect spans are purple.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
To change the color of the active (working) span, continue with
To change the color of the standby (protect) span, continue with
To return active and standby spans to their default colors, continue with
In the Span Colors area, click the colored square next to Active.
In the Pick a Color dialog box, click the color for the active span, or click the Reset button if you
want the active span to display the last applied (saved) color.
Click OK to close the Pick a Color dialog box. If you want to change the standby span color,
continue with Step 5. If not, click OK to save the change and close the Preferences dialog box, or
click Apply to save the change and keep the Preferences dialog box open.
In the Span Colors area, click the colored square next to Standby.
In the Pick a Color dialog box, click the color for the standby span, or click the Reset button if you
want the standby span to display the last applied (saved) color.
Click OK to save the change and close the Preferences dialog box, or click Apply to save the change
and keep the Preferences dialog box open.
From the Edit menu, choose Preferences.
In the Preferences dialog box, click the Circuits tab.
Click the Reset to Defaults button.
Click OK to save the change and close the Preferences dialog box, or click Apply to save the change
and keep the Preferences dialog box open.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Step 4.
Step 5.
Step 6.
17-17