Dlp-H17 Remove Sfp Connectors; Dlp-H18 Install Fiber-Optic Cables In A 1+1 Configuration - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99

DLP-H17 Remove SFP Connectors

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning Class 1 laser product. Statement 1008
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
beams or view directly with optical instruments. Statement 1051
Disconnect the network fiber cable from the SFP connector. Squeeze the sides of the fiber cable firmly
Step 1
to unlatch it.
Pull the bail clasp to the left to release the SFP.
Step 2
Slide the SFP out of the slot.
Step 3
Step 4 Return to your originating procedure (NTP).

DLP-H18 Install Fiber-Optic Cables in a 1+1 Configuration

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
On ONS 15310-MA SDH ports, the transmit and receive fiber for each optical signal are contained
Note
within a single SFP port.
Plan your fiber connections. Use the same plan for all 1+1 nodes.
Step 1
Align the keyed ridge of the cable connector with the transmit (Tx) connector of a working STM-M port
Step 2
at one node
working STM-M port at the adjacent node. The card displays an SF LED if the transmit and receive
fibers are mismatched (one fiber connects a receive port to a receive port, or a transmit port to a transmit
port).
78-19416-01
This task disconnects fiber attached to an SFP and removes the SFP.
None
DLP-H16 Install SFP Connectors, page 16-19
As needed
Onsite
None
This task installs fiber-optic cables on optical (STM-M) ports in a 1+1
linear configuration.
Fiber-optic cables
NTP-H109 Clean Fiber Connectors, page 14-11
As needed
Onsite
None
(Figure 16-14) and plug the other end of the fiber into the receive (Rx) connector of a
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-21