Dlp-H43 Provision The Iiop Listener Port On Ons 15310-Ma Sdh; Dlp-H44 Provision The Iiop Listener Port On The Ctc Computer - Cisco ONS 15310-MA SDH Procedure Manual

DLP-H43 Provision the IIOP Listener Port on ONS 15310-MA SDH

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If the Enable Proxy Server on port 1080 check box is checked, CTC will use port 1080 and ignore the
Note
configured IIOP port setting. If Enable Proxy Server is subsequently unchecked, the configured IIOP
listener port will be used.
In node view, click the Provisioning > Security > Access tabs.
Step 1
In the CTX CORBA (IIOP) Listener Port area, choose a listener port option:
Step 2
•
•
•
Click Apply.
Step 3
When the Change Network Configuration message appears, click Yes.
Step 4
The 15310E-CTX-K9 card reboots. The reboot takes approximately 4 to 6 minutes.
Return to your originating procedure (NTP).
Step 5

DLP-H44 Provision the IIOP Listener Port on the CTC Computer

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 From the Edit menu, choose Preferences.
Step 2 In the Preferences dialog box, click the Firewall tab.
Step 3 In the TCC CORBA (IIOP) Listener Port area, choose a listener port option:
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-60
This task sets the IIOP listener port on the ONS 15310-MA SDH, which
enables you to access ONS 15310 nodes that reside behind a firewall.
IIOP listener port number provided by your LAN or firewall administrator
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Default - CTX Fixed—Select this option if the ONS 15310-MA SDH nodes are on the same side of
the firewall as the CTC computer or if no firewall is used (default). This option sets the listener port
to Port 57790. It can be used for access through a firewall if Port 57790 is open.
Standard Constant—Select this option to use Port 683, the CORBA default port number, as the
listener port.
Other Constant—If Port 683 is not used, type the IIOP port specified by your firewall administrator.
This task selects the IIOP listener port on CTC.
IIOP listener port number provided by your LAN or firewall administrator
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Chapter 16 DLPs H1 to H99
78-19416-01