Ntp-H19 Create Users And Assign Security; Ntp-H20 Set Up Name, Date, Time, And Contact Information - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 3 Turn Up a Node
Stop. You have completed this procedure.

NTP-H19 Create Users and Assign Security

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with Step 2.
Note
Complete the
Step 2
Create a New User on Multiple Nodes" task on page 16-51
Note
If you want to modify the security policy settings, complete the
Step 3
Security" procedure on page
Stop. You have completed this procedure.

NTP-H20 Set Up Name, Date, Time, and Contact Information

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
78-19416-01
This procedure creates ONS 15310-MA SDH users and assigns their
security levels.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
As needed
Onsite or remote
Superuser
"DLP-H29 Log into CTC" task on page 16-43
You must log in as a Superuser to create additional users. The CISCO15 user provided with each
ONS 15310-MA SDH can be used to set up other ONS 15310 users. You can add up to 500 users
to one ONS 15310.
"DLP-H37 Create a New User on a Single Node" task on page 16-50
You must add the same user name and password to each node a user will access.
10-6.
This procedure provisions identification information for the node,
including the node name, a contact name and phone number, the location
of the node, and the date, time, and time zone.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
at the node where you need to create users.
or the
as needed.
"NTP-H83 Modify Users and Change
Before You Begin
"DLP-H38
3-3