Ntp-H103 Restore The Database - Cisco ONS 15310-MA SDH Procedure Manual

Hide thumbs Also See for ONS 15310-MA SDH:
Table of Contents

Advertisement

Chapter 14
Maintain the Node

NTP-H103 Restore the Database

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
The following parameters are not backed up and restored: node name, IP address, subnet mask and
gateway, and IIOP port. If you change the node name and then restore a backed up database with a
different node name, the circuits map to the new renamed node. Cisco recommends keeping a record of
the old and new node names.
Ethernet cards must be reset after a database restore. For information on restoring Ethernet cards, refer to
Note
the Cisco ONS 15310-CL and Cisco ONS 15310-MA Ethernet Card Software Feature and Configuration
Guide.
If you are restoring the database on multiple nodes, wait approximately one minute after the
Caution
15310E-CTX-K9 reboot has completed on each node before proceeding to the next node.
Complete the
Step 1
database. If you are already logged in, continue with Step 2.
In node view, click the Maintenance > Database tabs.
Step 2
Click Restore.
Step 3
Locate the database file stored on the workstation hard drive or on network storage.
Step 4
Note
Click the database file to highlight it.
Step 5
Click Open. The DB Restore dialog box appears.
Step 6
Opening a restore file from another node or from an earlier backup might affect traffic on the login node.
Caution
If you need a complete database restore, check the Complete database (System and Provisioning)
Step 7
check box. Continue with
78-19416-01
This procedure restores the 15310E-CTX-K9 (ONS 15310-MA SDH)
software database.
None
NTP-H102 Back Up the Database, page 14-2
As needed
Onsite or remote
Provisioning (if granted privilege through NE Defaults) or higher.
"DLP-H29 Log into CTC" task on page 16-43
To clear all existing provisioning, locate and upload the database found on the latest software
CD.
Step
9.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
at the node where you are restoring the
14-3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents