Dlp-H174 Clean Multi Fiber-Optic Cable Connectors - Cisco ONS 15310-MA SDH Procedure Manual

In node view, click the Maintenance > Protection tabs.
Step 1
In the Protection Groups list, click the protection group that contains the port you want to clear.
Step 2
In the Selected Group list, click the port you want to clear.
Step 3
In the Inhibit Switching area, click Unlock.
Step 4
Click Yes in the confirmation dialog box.
Step 5
The lock on or lockout is cleared.
Return to your originating procedure (NTP).
Step 6

DLP-H174 Clean Multi Fiber-Optic Cable Connectors

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
Warning
not stare into the beam or view directly with optical instruments. Statement 1051
Step 1 Remove the protective cap on the optical fiber cable connector.
Read the manufacturer (cleaning cartridge) instructions to insert the connector into the cleaning
Step 2
cartridge.
Step 3 Slide the lever on the cartridge to swipe the connector surface.
Insert the fiber connector into the applicable adapter or attach a dust cap to the fiber connector.
Step 4
If you must replace a dust cap on a connector, first verify that the dust cap is clean.
Note
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-66
This task cleans the multi fiber optic connectors
Cleaning Cartridge for multi fiber optic connectors
None
As needed
Onsite
None
Chapter 17 DLPs H100 to H199
78-19416-01