Cisco ONS 15310-MA SDH Procedure Manual page 156

Before You Begin
To route the circuit on a protected path, leave Fully Protected Path checked and continue with
•
Step
and alternate paths), and the path diversity options apply only to path protection path segments, if
any exist.
To create an unprotected circuit, uncheck Fully Protected Path and continue with
•
If you selected Fully Protected Path in
Step 13
configuration, choose one of the following:
Nodal Diversity Required—Ensures that the primary and alternate paths within the path protection
•
portions of the complete circuit path are nodally diverse.
Nodal Diversity Desired—Specifies that node diversity is preferred, but if node diversity is not
•
possible, CTC creates fiber-diverse paths for the path protection portion of the complete circuit path.
Link Diversity Only—Specifies that only fiber-diverse primary and alternate paths for path
•
protection portions of the complete circuit path are needed. The paths might be node-diverse, but
CTC does not check for node diversity.
Step 14 If you selected Fully Protected Path in
check the Dual Ring Interconnect check box.
Step 15 If you are creating a VC high-order path circuit, skip this step and continue with
creating a VC low-order path circuit, click Next and complete the
path and VC Low-order Path Grooming Nodes" task on page
Click Next. In the Route Review and Edit area, node icons appear for you to route the circuit manually.
Step 16
The green arrows pointing from the selected node to other network nodes indicate spans that are
available for routing the circuit.
Complete the
Step 17
E3 circuit that you are creating.
Click Finish.
Step 18
If you entered more than 1 in the Number of Circuits field, the Circuit Creation dialog box appears for
Step 19
you to create the remaining circuits. Repeat Steps
When all the circuits are created, the main Circuits window appears. Verify that the circuits you created
Step 20
appear in the window.
Complete the
Step 21
test circuit.
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
5-20
13. Fully protected paths might or might not have path protection path segments (with primary
"DLP-H60 Provision a E1, DS-3, or E3 Circuit Route" task on page 16-78
"NTP-H46 Test Electrical Circuits" procedure on page
Chapter 5 Create Circuits and VC Low-order Path Tunnels
Step 12 and the circuit will be routed on a path protection
Step 12 and the circuit will be routed on a path protection DRI,
16-77.
5 through 17 for each additional circuit.
Step
Step 16. If you are
"DLP-H59 Provision VC high-order
for the DS-3 or
5-24. Skip this step if you built a
78-19416-01
15.