Ntp-C186 Manually Create A Ccat Or Vcat Circuit On The Ce-Mr-10 Card - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 5 Create Circuits and VC Low-order Path Tunnels
NTP-C186 Manually Create a CCAT or VCAT Circuit on the
CE-MR-10 Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with
In the node view, double-click the CE-MR-10 card.
Step 2
Click the Circuits > Circuits tabs.
Step 3
Click Create.
Step 4
In the Circuit Creation dialog box, choose STS-V or VT-V from the Circuit Type drop-down list.
Step 5
Click Next.
Step 6
Define the circuit attributes:
Step 7
•
•
•
•
•
78-19416-01
This procedure manually creates a CCAT or VCAT circuit on the
CE-MR-10 Card.
None
NTP-H36 Verify Network Turn-Up, page 5-4
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits. If you leave the field blank, CTC assigns a default name to the circuit.
Type—Displays the circuit type you chose in
Bidirectional—Checked is the default. You cannot change it.
Create cross-connects only (TL1-like)—Check this box if you want to create one or more
cross-connects to complete a signal path for TL1-generated circuits.
State—Choose the administrative state to apply to all of the member cross-connects in a VCAT
circuit:
IS—Puts the member cross-connects in the IS-NR service state.
–
OOS,DSBLD—Puts the member cross-connects in the OOS-MA,DSBLD service state. Traffic
–
is not passed on the circuit.
IS,AINS—Puts the member cross-connects in the Out-of-Service and Autonomous, Automatic
–
In-Service (OOS-AU,AINS) service state. When the connections receive a valid signal, the
cross-connect service states automatically change to IS-NR.
OOS,MT—Puts the member cross-connects in the OOS-MA,MT service state. This service
–
state does not interrupt traffic flow and allows loopbacks to be performed on the circuit, but
suppresses alarms and conditions. Use the OOS,MT administrative state for circuit testing or to
suppress circuit alarms temporarily. Change the administrative state to IS; OOS; or IS,AINS
when testing is complete.
Step 2.
Step 5. You cannot change it.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
at the node where you will create the circuit.
Before You Begin
5-55