Dlp-H218 Soft-Reset A 15310E-Ctx-K9 Card Using Ctc - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Step 4 If you want to delete all the dynamically generated TDC entries, click the Flush Dynamic Entries
button. If not, continue with
Step 5 Return to your originating procedure (NTP).

DLP-H218 Soft-Reset a 15310E-CTX-K9 Card Using CTC

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Soft-resetting the 15310E-CTX-K9 cards causes a traffic hit only if a provisioning change or firmware
Caution
update has occurred. Otherwise, the soft reset is errorless.
Caution Do not soft reset more than one ONS 15310-MA SDH card at a time. Instead, issue a soft reset command
for a single card, then wait until CTC shows the card is back up. You can then issue a soft reset on another
card if needed. Completing soft resets in sequence helps to avoid unexpected traffic hits.
Before you reset the 15310E-CTX-K9 card, you should wait at least 60 seconds after the last
Note
provisioning change to avoid losing any changes to the database.
The 15310E-CTX-K9 cards do not support a real time clock with battery backup. Hence, during a card
Note
reset, the time is reset to default and the date starts at 1970 till you set the time/date again.
A software reset causes a standard Telcordia protection switch of less than 50 ms.
Note
In node view, right-click the 15310E-CTX-K9 card to reveal a drop-down list.
Step 1
Click Soft-Reset Card.
Step 2
78-19416-01
If TARP finds the TID in its TDC, it returns the matching NSAP. If not, TARP sends PDUs across
the network. Replies will return to the TDC later, and a "check TDC later" message is displayed.
Step
This task resets a 15310E-CTX-K9 (ONS 15310-MA SDH) card using
a soft reset. A soft reset reboots the card and reloads the operating
system and the application software. If there are two 15310E-CTX-K9
cards installed on the ONS 15310 MA the standby 15310E-CTX-K9
will become active after issuing an active CTX soft-reset.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Maintenance or higher
5.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-15