Ntp-H42 Create A Unidirectional Ds-3 Or E3 Circuit With Multiple Drops - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 5 Create Circuits and VC Low-order Path Tunnels
NTP-H42 Create a Unidirectional DS-3 or E3 Circuit with
Multiple Drops
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the circuit. If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
From the View menu, choose Go to Network View.
Step 3
Click the Circuits tab, then click Create.
Step 4
In the Circuit Creation dialog box, complete the following fields:
Step 5
•
•
•
Click Next.
Step 6
Define the circuit attributes:
Step 7
•
•
•
•
•
•
78-19416-01
This procedure creates a unidirectional DS-3 or E3 circuit with multiple
drops.
None
NTP-H36 Verify Network Turn-Up, page 5-4
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H56 Assign a Name to a Port" task on page
Circuit Type—Choose VC high-order path (both DS-3 and E3) or VC low-order path (E3 only).
Number of Circuits—Leave the default unchanged (1).
Auto-ranged—Unavailable when the Number of Circuits is 1.
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits. If you leave the field blank, CTC assigns a default name to the circuit.
Size—If you are creating a VC high-order path circuit, choose VC3. If you are creating a VC
low-order path circuit, Size displays VC-12 and cannot be changed.
Bidirectional—Uncheck for this circuit.
Create cross-connects only (TL1-like)—Check this check box if you want to create one or more
cross-connects to complete a signal path for TL1-generated circuits. Also, VC low-order path
tunnels and Ethergroup sources and destinations are unavailable.
Diagnostic—Leave the default (unchecked).
State—Choose the administrative state to apply to all of the cross-connects in a circuit:
unlocked—Puts the circuit cross-connects in the unlocked-enabled service state.
–
locked, outOfGroup—Puts the circuit cross-connects in the locked-enabled,disabled service
–
state. Traffic is not passed on the circuit.
Automatic In Service—Puts the circuit cross-connects in the
–
unlocked-disabled,automaticInService service state and suppresses alarms and conditions.
When the connections receive a valid signal, the service state automatically changes to
unlocked-enabled.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
at a node on the network where you will
Step 2.
16-75. If not, continue with Step 3.
5-21