Ntp- H153 Install The 15310E-Ctx-K9 Cards - Cisco ONS 15310-MA SDH Procedure Manual

Required Tools and Equipment
Use the ejector to slide the fan tray into the shelf assembly until the electrical plug at the rear of the tray
Step 4
plugs into the corresponding receptacle on the backplane.
Step 5 Close the ejector.
Use a Phillips screwdriver to tighten the screws at either end of the fan-tray assembly.
Step 6
To verify that the tray has plugged into the backplane, look at the fan tray and listen to determine that
Step 7
the fans are running.
Figure 1-7
Figure 1-7
Continue with the
Step 8
Stop. You have completed this procedure.
NTP-H153 Install the 15310E-CTX-K9 Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
1-16
shows the location of the fan-tray assembly.
Installing the Fan-Tray Assembly
"NTP-H153 Install the 15310E-CTX-K9 Cards" procedure on page
This procedure installs 15310E-CTX-K9 cards in the ONS 15310-MA
SDH.
None
DLP-H8 Turn On and Verify DC Office Power on the ONS 15310-MA
SDH, page 16-9
Required
Onsite
Retrieve or higher
Chapter 1 Install the Cisco ONS 15310-MA SDH
1-16.
78-19416-01