Cisco ONS 15310-MA SDH Procedure Manual page 323

Chapter 16 DLPs H1 to H99
In the Control Panel dialog box, click the Network icon.
b.
In the Network dialog box, select TCP/IP for your PC Ethernet card, then click Properties.
c.
In the TCP/IP Properties dialog box, click the DNS Configuration tab and choose Disable DNS.
d.
Click the WINS Configuration tab and choose Disable WINS Resolution.
e.
Click the IP Address tab.
f.
In the IP Address window, click Specify an IP address.
g.
In the IP Address field, enter an IP address that is identical to the ONS 15310-MA SDH IP address
h.
except for the last octet. For example, if the node IP address is 209.165.201.30, your IP address must
be 209.165.201.xxx, where xxx is any number up to 255 excluding 30, which is used in the node IP
address.
i. In the Subnet Mask field, type the same subnet mask as the ONS 15310-MA SDH. The default is
255.255.255.0 (24 bit).
j. Click OK.
k. In the TCP/IP dialog box, click the Gateway tab.
l. In the New Gateway field, type the ONS 15310-MA SDH IP address. Click Add.
Verify that the IP address appears in the Installed Gateways field, then click OK.
m.
When the prompt to restart your PC appears, click Yes.
n.
If you have Windows NT 4.0 installed on your PC, complete the following steps to change its TCP/IP
Step 4
configuration:
From the Windows Start menu, choose Settings > Control Panel.
a.
In the Control Panel dialog box, click the Network icon.
b.
In the Network dialog box, click the Protocols tab, choose TCP/IP Protocol, then click Properties.
c.
Click the IP Address tab.
d.
In the IP Address window, click Specify an IP address.
e.
In the IP Address field, enter an IP address that is identical to the ONS 15310-MA SDH IP address
f.
except for the last octet. The last octet must be 1 or 3 through 254.
In the Subnet Mask field, type 255.255.255.0.
g.
Click Advanced.
h.
In the Gateways List, click Add. The TCP/IP Gateway Address dialog box appears.
i.
Type the ONS 15310-MA SDH IP address in the Gateway Address field.
j.
Click Add.
k.
l. Click OK.
m. Click Apply.
n. In some cases, Windows NT 4.0 prompts you to reboot your PC. If you receive this prompt, click
Yes.
Step 5 If you have Windows 2000 installed on your PC, complete the following steps to change its TCP/IP
configuration:
From the Windows Start menu, choose Settings > Network and Dial-up Connections > Local
a.
Area Connection.
In the Local Area Connection Status dialog box, click Properties.
b.
78-19416-01
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-33