Dlp-H93 Monitor Far-End Pm Counts - Cisco ONS 15310-MA SDH Procedure Manual

In node view, double-click the 15310E-CTX-K9, electrical, or Ethernet card. The card view appears.
Step 1
Note
Click the Performance tab.
Step 2
Click the E1, DS3, or Optical tabs.
Step 3
Click the Near End radio button.
Step 4
Click Refresh. All PM parameters for the selected card on the incoming signal appear. For PM parameter
Step 5
definitions refer to the "Performance Monitoring" chapter in the Cisco ONS 15310-MA SDH Reference
Manual.
Step 6 View the Curr column to find PM counts for the current time interval.
View the Prev-n columns to find PM counts for the previous time intervals.
Step 7
Return to your originating procedure (NTP).
Step 8

DLP-H93 Monitor Far-End PM Counts

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click an 15310E-CTX-K9, electrical, or Ethernet card. The card view appears.
Step 1
Note
Click the Performance tab.
Step 2
Click the E1, DS3, or Optical tabs
Step 3
Click the Far End radio button.
Step 4
Note
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-110
In an ONS 15310-MA SDH node, the 15310E-CTX-K9 card provides optical ports and the
E1_21_E3_DS3_3 and E1_63_E3_DS3_3 cards provide electrical ports. The ONS 15310-MA
SDH supports Ethernet cards.
Use this task to view far-end PM parameters for the selected card and
port.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
In an ONS 15310-MA SDH node, the 15310E-CTX-K9 card provides optical ports and the
E1_21_E3_DS3_3 and E1_63_E3_DS3_3 cards provide electrical ports. The ONS 15310-MA
SDH supports Ethernet cards.
Only cards that allow far-end performance monitoring have this button as an option.
Chapter 16 DLPs H1 to H99
78-19416-01