Dlp-H282 Create An Snmpv3 User - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Right-click the span where you want to switch SNCP traffic away. Choose Circuits from the shortcut
Step 2
menu.
Step 3 In the Circuits on Span dialog box, choose FORCE SWITCH AWAY. Click Apply.
In the Confirm SNCP Switch dialog box, click Yes.
Step 4
In the Protection Switch Result dialog box, click OK.
Step 5
In the Circuits on Span window, the Switch State for all circuits is FORCE.
Note
Note
Step 6 Return to your originating procedure (NTP).

DLP-H282 Create an SNMPv3 User

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > SNMP > SNMP V3 > User tabs.
Step 1
Click Create.
Step 2
In the Create User dialog box, enter the following information:
Step 3
•
•
•
•
78-19416-01
A Force switch request on a span or card causes CTC to raise a FORCED-REQ condition. The
condition clears when you clear the force switch; it is informational only.
The ONS 15310-MA and the 15310E-CTX-K9 card do not support SNCP switching for VC3
circuits containing BIP errors. The SF/SD alarm is not raised for VC3 circuits.
This procedure creates an SNMPv3 user.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
User Name—Specify the name of the user on the host that connects to the agent. The user name must
be a minimum of six and a maximum of 20 alphanumeric (a-z, A-Z, 0-9) characters. For TL1
compatibility, the user name must be of 6 to 10 characters.
Group Name—Specify the group to which the user belongs.
Authentication
Protocol—Select the authentication algorithm that you want to use. The options are NONE,
–
MD5, and SHA.
Password—Enter a password if you select MD5 or SHA. By default, the password length is set
–
to a minimum of eight characters.
Privacy—Initiates a privacy authentication level setting session that enables the host to encrypt the
contents of the message that is sent to the agent.
Protocol—Select NONE or DES as the privacy authentication algorithm.
–
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-81