Chapter 10 Change Node Settings; Before You Begin - Cisco ONS 15310-MA SDH Procedure Manual

Change Node Settings
This chapter explains how to modify node provisioning for the Cisco ONS 15310-MA SDH. To
provision a new node, see
settings, refer to the "Network Element Defaults" appendix in the Cisco ONS 15310-MA SDH Reference
Manual.

Before You Begin

Before performing the following procedures, investigate all alarms and clear any trouble conditions.
Refer to the Cisco ONS 15310-MA SDH Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
8.
9.
78-19416-01
Chapter 3, "Turn Up a Node."
NTP-H78 Change Node Management Information, page
to change the node name, contact information, latitude, longitude, date, time, and login legal
disclaimer.
NTP-H79 Change CTC Network Access, page
the IP address, default router, subnet mask, network configuration settings, and static routes.
NTP-H133 Modify OSI Provisioning, page
Open System Interconnection (OSI) parameters including the OSI routing mode, Target Identifier
Address Resolution Protocol (TARP), routers, subnets, and IP-over-OSI tunnels.
NTP-H80 Customize the CTC Network View, page
customize the appearance of the network map, including specifying the default map, selecting your
own map or image, consolidating links, and changing the background color.
NTP-H143 Modify or Delete Card Protection Settings, page
NTP-H82 Change Node Timing, page
NTP-H83 Modify Users and Change Security, page
change the security policy on one or more nodes, change the node access and PM clearing privilege,
grant superuser privileges to provisioning users, change the user password and security settings on
one or more nodes, delete and logout users on one or more nodes, and configure the node for
RADIUS authentication.
NTP-H84 Change SNMP Settings, page
NTP-H85 Modify or Delete Communications Channel Terminations and Provisionable Patchcords,
page 10-7—Complete as needed.
C H A P T E R
To change default card-level and node-level
10-2—As needed, complete this procedure to change
10-3—Complete this procedure as needed to modify
10-4—As needed, complete this procedure to
10-5—Complete as needed.
10-6—As needed, complete this procedure to
10-7—Complete as needed.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
10
10-2—As needed, complete this procedure
10-4—Complete as needed.
10-1