Cisco ONS 15310-MA SDH Procedure Manual page 428

Click Next.
Step 7
To route the members automatically, check Route Automatically. To manually route the members, leave
Step 8
Route Automatically unchecked.
If you want to set preferences for individual members, complete the following in the Member
Step 9
Preferences area. To set identical preferences for all added members, skip this step and continue with
Step 10.
Note
• Number—Choose a number from the drop-down list to identify the member.
Name—Enter a unique name to identify the member. The name can be alphanumeric and up to
•
48 characters (including spaces). If you leave the field blank, CTC assigns a default name to the
circuit.
• Protection—Choose the member protection type:
Node-Diverse Path—(Split routing only) Available for each member when Fully Protected is
•
chosen.
To set preferences for all members, complete the following in the Set Preferences for All Members area:
Step 10
Protection—Choose the member protection type:
•
Node-Diverse Path—(Split routing only) Available when Fully Protected is chosen.
•
If you left Route Automatically unchecked in
Step 11
you checked Route Automatically in
In the Route Review/Edit area of the Circuit Creation wizard, choose the member to route from the
a.
Route Member number drop-down list.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-22
administrative state for circuit testing or to suppress circuit alarms temporarily. Change the
administrative state to unlocked; OOS; or Automatic In Service when testing is complete. See
the "DLP-H180 Change a VCAT Member Service State" task on page
locked, outOfGroup—(LCAS VCAT only) Puts VCAT member cross-connects in the
–
Out-of-Service and Management, Out-of-Group (locked-enabled,outOfGroup) service state.
This administrative state is used to put a member circuit out of the group and to stop sending
traffic.
Common fiber or split routing cannot be changed.
– Fully Protected—Routes the circuit on a protected path.
– Unprotected—Creates an unprotected circuit.
PCA—(Future use) Routes the member on a MS-SPRing protection channel.
–
DRI—(Split routing only) Routes the member on a dual ring interconnect circuit.
–
Fully Protected—Routes the circuit on a protected path.
–
Unprotected—Creates an unprotected circuit.
–
PCA—(Future use) Routes the member on a MS-SPRing protection channel.
–
Although ONS 15310-MAs do not support MS-SPRing, you can route an LCAT VCAT
Note
circuit over a MS-SPRing network of ONS 15600, ONS 15454, or ONS 15327 nodes.
DRI—(Split routing only) Routes the member on a dual ring interconnect circuit.
–
Step 8, click Next and complete the following substeps. If
Step 8, continue with Step
Chapter 17 DLPs H100 to H199
17-70.
12.
78-19416-01