Chapter 15 Power Down The Node; Ntp-H120 Power Down The Ons 15310-Ma Sdh - Cisco ONS 15310-MA SDH Procedure Manual

Power Down the Node
This chapter explains how to power down a Cisco ONS 15310-MA SDH node and stop all node activity.

NTP-H120 Power Down the ONS 15310-MA SDH

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The following procedure is designed to minimize traffic outages when powering down nodes, but traffic
Caution
will be lost if you delete and recreate circuits that passed through a working node.
Always use the supplied ESD wristband when working with the ONS 15310-MA SDH. For detailed
Caution
instructions on how to wear the ESD wristband, refer to the
and Grounding
Identify the node that you want to power down. If no cards are installed, go to Step 13. If a card is
Step 1
installed, log into the node. See the
In node view, choose Go to Network view from the View menu.
Step 2
Verify that the node is not connected to a network.
Step 3
a.
b.
78-19416-01
This procedure stops all node activity.
None
None
As needed
Onsite
For software steps, the Provisioning level or higher is required. For
hardware steps, any level is allowed.
Guide.
If the node is part of a working network, log out of the node and complete the
a Path Protection Node" procedure on page 13-4
from a Linear ADM" procedure on page
If the node is not connected to a working network and the current configurations are no longer
required, continue with Step
C H A P T E R
"DLP-H29 Log into CTC" task on page 16-43
or the
13-9. Continue with
4.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
15
Cisco ONS Electrostatic Discharge (ESD)
for instructions.
"NTP-H98 Remove
"NTP-H101 Remove an In-Service Node
Step 4.
15-1