Dlp-H63 Provision An Stm-M Circuit Source And Destination - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99

DLP-H63 Provision an STM-M Circuit Source and Destination

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Node drop-down list, choose the node where the circuit will originate.
Step 1
From the Slot drop-down list, choose the slot where the circuit originates. (If a card's capacity is fully
Step 2
utilized, it does not appear in the list.)
Depending on the circuit origination card, choose the source port and/or VC high-order path from the
Step 3
Port and VC high-order path drop-down lists.VC high-order paths do not appear if they are already in
use by other circuits.
Step 4 If you are creating a VC low-order path circuit, choose the VC low-order path from the VC low-order
path drop-down list.
Step 5 If you need to create a secondary source, for example, a path protection bridge/selector circuit entry
point in a multivendor path protection configuration, click Use Secondary Source and repeat Steps
through
Click Next.
Step 6
From the Node drop-down list, choose the destination node.
Step 7
From the Slot drop-down list, choose the slot where the circuit will terminate (destination card). (If a
Step 8
card's capacity is fully utilized, the card does not appear in the list.)
Depending on the card selected in
Step 9
the Port and VC high-order path drop-down lists.
If you are creating a VC low-order path circuit, choose the VC low-order path from the VC low-order
Step 10
path drop-down list.
If you need to create a secondary destination, for example, a path protection bridge/selector circuit entry
Step 11
point in a multivendor path protection configuration, click Use Secondary Destination and repeat Steps
7 through
Step 12 Click Next.
Return to your originating procedure (NTP).
Step 13
78-19416-01
This task provisions the source and destination cards for an STM-M
circuit.
None
DLP-H29 Log into CTC, page 16-43
The Circuit Creation wizard Circuit Source page must be open.
As needed
Onsite or remote
Provisioning or higher
4 to define the secondary source.
10 to define the secondary destination.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Step 2, choose the destination port and/or VC high-order path from
1
16-81