Ntp-H14 Set Up Tl1 Session For Local Craft Connection To The Node; Chapter 2 Connect The Pc And Log Into The Gui - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 2 Connect the PC and Log into the GUI
NTP-H14 Set Up TL1 session for Local Craft Connection to the
Node
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Connect a straight-through CAT-5 LAN cable from the PC or Solaris workstation NIC to one of the
Step 1
following:
•
Craft Interface Connection—The Craft Interface located on the front of the CTX-2500 card. The RJ-45
port supports VT100 emulation such that TL1 commands can be entered directly to the Node without a
browser connection.
Access hyper-terminal from your Windows pc
Step 2
Step 3 Configure the terminal emulation software (Hyper-terminal) with the following values:
•
•
•
•
•
Press Enter. An angle bracket prompt (>) appears.
Step 4
Login to the Node using the ACT-USER command
Step 5
Stop. You have completed this procedure.
78-19416-01
This procedure sets up a PC running Windows or a UNIX/Solaris
workstation for an onsite local craft connection to the node.
Network interface card (NIC), also referred to as an Ethernet card
Straight-through (CAT-5) LAN cable
NTP-H13 Set Up Computer for CTC, page 2-1
As needed
Onsite or remote
None
RJ-45 (CRAFT) port on the ONS 15310-MA SDH
For instructions on crimping your own straight-through (CAT-5) LAN cables, refer to the
Note
Cisco ONS 15310-MA SDH Troubleshooting Guide.
For initial shelf turn-up, you should connect your PC directly to the CRAFT port on the ONS
Note
15310-MA SDH. On the ONS 15310-MA SDH, the CRAFT port is located on the
15310E-CTX-K9 card.
Terminal emulation = vt100
Bits per second = 9600
Parity = None
Stop BITS = 1
Flow control = None
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
2-3